Using the rear toggle switch I then shut down the Drobo Pro. used USB and iscsi connections - same error message.I tried relaunching several times, same message after a few minutes, so I then downloaded the dashboard again from the Drobo web site and re-installed, re-booted Mac, same thing - X: "a required portion etc… X: “a required portion of Drobo Dashboard is no longer running. Started up the Drobo Dashboard, which could not find any Drobos - then a message appeared on the Drobo Dashboard panel:.then connected the power cable to the Drobo Pro and used the rear toggle switch to start up the Drobo Pro, which went through it’s sequence then went into standby mode, but drive number 1 (on the left) had a solid red light, all the remaining slots 2-8 were not lit at all….with the power off and the connection to the Mac, I removed all the drives and numbered them to maintain the sequence for their re-inserion….(does it now wake up and ultimately become recognised by drobo?)ĭisk packs should only be removed when power is all OFFĭisk packs should only be put back in, when power is all OFF (does it now boot up with blue led sequence and then go into standby mode? or do you hve the same issue)Įither way, to then power up the computer and dashboard as before,Īnd to then connect the computer cable into drobo and to power up the drobo without any connection cable.to then put yoru drives back into where they were before.and then power off the computer, and then the drobo.you can then safely shut down the drobo via dashboard.If yes, then the main unit seems to be ok, and: (does the drobo wake up shortly after that, and then does dashboard recognise it?) to then connect the computer cable to the drobo (starting with your usual method, but all steps might need repeating with different connection slots, and/or different connection methods such as a usb cable).to then power up the computer, and once that is running, to launch dashboard service and programs.(does it boot up and then go into standby mode?) to then power up the empty drobo on its own.to remove each drive, remembering the order for later (these make up your disk pack).to remove all cables and power from drobo.to power off the computer, and then the drobo once in standby mode (you might need to unplug the connection cable from drobo and wait a bit for it to go into standby mode, but might also need to power it off if it froze).One thing you could try initially could be a test to see whether the main unit is still ok, such as this: Low Coolant Light - do not continue your journey until coolant level is checked (from cold).Can you remember anything more about what happened just before the issue when things were still working last, or if any events took place (such as power cuts or something?) Handbrake Light - Indicating handbrake is on or fault with braking system. Transmission Fault - Fault stored in transmission ECU - Requires specialist attention. Tire Pressure Warning Light - Vehicle has detected low pressure in at least one tire.Īirbag Warning Light - If light is on constant, all airbags are inactive due to fault.Ĭharging Light - Low Battery Power / Vehicle Not Charging.īrake Pads Low - Warning Light - will require replacement. Traction Control - Off Or Inactive (Faulty). Vehicles With Stop, Start Technology - Fault with system. Parking Brake - On or fault with parking brake system. Low Washer Jet Fluid - Requires Refilling.ĮML - Engine Management Light - Requires Investigation (Please book the vehicle in for diagnostic). For instance, the need to fill your windshield washer fluid, or close a door. Routine and Common Indicators The following symbols are intended to point out routine needs for your vehicle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |